I can hear the call ringing in the car speakers, I can answer it but after that it's silent.ġ. The phone connects, I have the battery and network status on the screen of my car, I can receive SMS on the car's screen, I can stream music to the speakers but I cannot hear anything while in a call. I anyway ended up following the instructions and all went well except that I am now unable to hear anything while in a phone call connected to the Bluetooth in my car. Unfortunately I forgot to check at dis-assembly which screw goes back where at step 11 so I ended up following the instructions although, I would find it logical that the longer screws are for the top and the shorter ones for the bottom holes, which is what you mentioned also.
But sadly after repeated and careful attempts to reseat it, my Touch ID is lost for good. Judging by this experience the Touch ID cable/pins must be insanely sensitive – perhaps one pin was dislodged by a fraction of a millimeter? I can’t say for sure.
Display wechsel iphone 5 how to#
Even after I re-opened the phone two more times and finally figured out how to properly reseat the bracket, Touch ID was gone. I finished the battery replacement, and put the cable back in place only to discover: no Touch ID. This gave me a start but I inspected both parts and they appeared to be fine. In my case, as I carefully used the spudger to release the bracket, the released tension shot the bracket out of the phone and the Touch ID cable popped out of its socket with it. The front of the bracket is the point of tension that holds it in place. Thank you to that commenter, otherwise am not sure I could’ve done it.īe forewarned: make sure you really really want that new battery or display replacement, because you are VERY likely to lose your Touch ID feature on your phone after taking this step. Luckily there are only very minor nicks (hardly even visible) on the metal. This approach totally worked for me so that I could get the frame lifted just enough to slide in plastic cards and wedges until I could switch over to the plastic opening tools. I knew I might end up scraping the metal but nothing else was thin enough to work. After several failed attempts of using plastic opening tools to wedge between the frame and the phone body, I ended up using an exacto-knife (a Stanley knife) based on another commenters suggestion. After several tries I was able to get a firm attachment, however, the result was that the glass was being pulled up without the plastic rim. I had used packing tape on it to keep the bits from falling apart while I waited for the replacement part, however, the tape limited my ability to use the suction cup for removal.
Display wechsel iphone 5 cracked#
I was replacing my 5s screen due to a cracked screen.
0 kommentar(er)
